ILC - International Linear Collider

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

survey:main_linac [2006/10/25 00:19]
s_a
survey:main_linac [2006/12/28 19:37] (current)
s_a
Line 1: Line 1:
-Following are the tolerances for the alignment of quadrupoles+There are two sources for the ML requirements: 
 + 
 +1. 300 μm / 200 m. (We assume this is quad to quad) and 2 mm / km global. Source:  (Chris Adolphson) 
 + 
 +2. Following are the tolerances for the alignment of quadrupoles
 and cavities in the Main Linac Area. and cavities in the Main Linac Area.
 This information was obtained from Kiyoshi Kubo who is the This information was obtained from Kiyoshi Kubo who is the
 
survey/main_linac.txt · Last modified: 2006/12/28 19:37 by s_a
 
Recent changes RSS feed